升降舞臺如何確保其安全性？

升降舞臺http://www.8kvv.com/是每個劇場都需要的，舞臺設計中要更多考慮安全的問題。那么應該如何確保升降舞臺的安全呢？

1、升降舞臺安裝剎車裝置用來控制升降機曳引機器部分起動遏制的制動器。
Landing stage install brakes to control the elevator hoisting machine start-stop brake part.
2、升降舞臺安裝限位開關以限止轎廂開到最高位置或最低位置不能擔當運轉的裝配。
Landing stage limit switches to limiting the car open to the highest or lowest position can not assume the position of the assembly operation.

3、升降舞臺安裝越程開關以使轎廂行駛到最高位置或最低位置時，轎廂就會擔當上升或下降。舞臺設備為了防備轎廂沖頂或沉底，應拆卸能切斷電源和不能自動復位的越程開關，并裝在機房內，而不能裝在井道內，應裝設具有領受舉動機構能量并減少沖擊的緩沖器。
When the landing stage overtravel switches installed with the car to its highest position or the lowest position, the car will serve as rising or falling. Stage equipment in order to prepare the car jump or sink to the bottom, you should be able to cut off the power supply and can not disassemble automatic reset overtravel switch and installed in the engine room, but can not be installed in the shaft, should be installed with a move bodies receive energy and reduce the impact of buffer.
4、為了增添轎廂沖頂或沉底的能量，安裝升降舞臺http://www.8kvv.com/緩沖器與轎廂觸碰處拆卸橡皮或海綿，以增添其沖擊能量，繩槽打滑等導致轎廂突然墜落事變。
In order to increase the energy of the car jump or sink to the bottom, and the car bumper installation landing stage at dismantling touch rubber or sponge to increase its impact energy, rope groove slip suddenly fall as a result of the car incident.
5、為了防止由于吊重鋼絲繩斷裂，應在轎廂上拆卸能同時切斷控制電源和使轎廂停止下墜的保險鉗。
In order to prevent the hoist rope breaks, should be able to cut off the demolition control power and stop the car falling clamp on the car insurance.